Menu
Forum
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Gallery
New media
New comments
Search media
Members
Registered members
Current visitors
Classifieds Member Feedback
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Register
Forum
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
Log in / Join
What’s new
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Menu
Reply to thread
Forum
Car Audio Discussion
Amplifiers
2 channel and mono?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="gunz4me" data-source="post: 5781265" data-attributes="member: 596464"><p>The AQ1200D <strong>DOES NOT</strong> have two channels. What it has are two sets of speaker outputs tied to the single MONO output. How you wire it is up to you. You can wire one sub to each set of outputs OR use only one set of + and - to wire both subs.</p><p></p><p>Series the voice coils on each sub then parallel them for a 4 ohm final nominal load OR parallel the coils on each sub (+ to + and - to -) then parallel both subs together for a 1 ohm load.</p><p></p><p>Click <a href="http://www.the12volt.com/caraudio/woofer_configurations.asp?Q=2&amp;I=42" target="_blank">*here*</a> for your wiring options!</p></blockquote><p></p>
[QUOTE="gunz4me, post: 5781265, member: 596464"] The AQ1200D [B]DOES NOT[/B] have two channels. What it has are two sets of speaker outputs tied to the single MONO output. How you wire it is up to you. You can wire one sub to each set of outputs OR use only one set of + and - to wire both subs. Series the voice coils on each sub then parallel them for a 4 ohm final nominal load OR parallel the coils on each sub (+ to + and - to -) then parallel both subs together for a 1 ohm load. Click [URL="http://www.the12volt.com/caraudio/woofer_configurations.asp?Q=2&I=42"]*here*[/URL] for your wiring options! [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Discussion
Amplifiers
2 channel and mono?
Top
Menu
What's new
Forum list
