Menu
Forum
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Car Audio Discussion
General Car Audio
Car Audio Build Logs
Car Audio Equipment
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Help
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Car Audio Classifieds
Car Audio Wanted
Classifieds Member Feedback
Gallery
New media
New comments
Search media
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Join
Test
Forum
Search
Search titles only
Search titles only
Log in / Join
Search
Search titles only
Search titles only
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Menu
Reply to thread
Forum
Car Audio Help
Wiring, Electrical & Installation
2 amps, will i have enough power?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="Unregistered" data-source="post: 10152"><p>I have a nakamichiPA504 50Wx4-driving 4 JL-XR components, and a JL-300/2-driving 2 JL-12W0's. Im about to add the JL-300/2, before with the nak amp itself driving the 12W0's I would get some dimming of lights at peak volume. Im going to use the nak for my components and use the new JL amp to drive my subs. I was wondering should I split a Y for the fused battery wire or run the fused battery wire as a chain from amp to amp. If Im not going to have enough power(dimming lights) should I install a cap, if so where?, before both amps or before just one, or two caps before each amp?</p><p></p><p>Will the cap help with the dimming lights?</p><p></p><p>Thanks,</p><p></p><p>MM</p></blockquote><p></p>
[QUOTE="Unregistered, post: 10152"] I have a nakamichiPA504 50Wx4-driving 4 JL-XR components, and a JL-300/2-driving 2 JL-12W0's. Im about to add the JL-300/2, before with the nak amp itself driving the 12W0's I would get some dimming of lights at peak volume. Im going to use the nak for my components and use the new JL amp to drive my subs. I was wondering should I split a Y for the fused battery wire or run the fused battery wire as a chain from amp to amp. If Im not going to have enough power(dimming lights) should I install a cap, if so where?, before both amps or before just one, or two caps before each amp? Will the cap help with the dimming lights? Thanks, MM [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Help
Wiring, Electrical & Installation
2 amps, will i have enough power?
Top
Menu
Home
Refresh