Menu
Forum
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Car Audio Discussion
General Car Audio
Car Audio Build Logs
Car Audio Equipment
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Help
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Car Audio Classifieds
Car Audio Wanted
Classifieds Member Feedback
Gallery
New media
New comments
Search media
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Join
Test
Forum
Search
Search titles only
Search titles only
Log in / Join
Search
Search titles only
Search titles only
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Menu
Reply to thread
Forum
Car Audio Help
Wiring, Electrical & Installation
2 Amps installed...Sub amp not pushing enough power!!!
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="858SD" data-source="post: 8219299" data-attributes="member: 659466"><p>However the voice coils are hooked up, its the same from when it was in the soundstream. I never opened up the box to see how its wired inside since i had the sub. I will do that when i get a chance. But as how i hooked it up to the amps each amp has 2 pos and neg terminals..I just connect the 1st pos to the 1st neg and the terminals are like (+)(+)(-)(-). But when bridged to the soundstream it was to the first pos and last neg,if that helps anything..Can you explain real fast whats the difference between series and parallel and whats the best for my sub?</p><p></p><p>On another note is the kenwood still not as good as the alpine and soundstream even tho it has more power than the alpine? or in general is kenwood just not a good amp</p></blockquote><p></p>
[QUOTE="858SD, post: 8219299, member: 659466"] However the voice coils are hooked up, its the same from when it was in the soundstream. I never opened up the box to see how its wired inside since i had the sub. I will do that when i get a chance. But as how i hooked it up to the amps each amp has 2 pos and neg terminals..I just connect the 1st pos to the 1st neg and the terminals are like (+)(+)(-)(-). But when bridged to the soundstream it was to the first pos and last neg,if that helps anything..Can you explain real fast whats the difference between series and parallel and whats the best for my sub? On another note is the kenwood still not as good as the alpine and soundstream even tho it has more power than the alpine? or in general is kenwood just not a good amp [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Help
Wiring, Electrical & Installation
2 Amps installed...Sub amp not pushing enough power!!!
Top
Menu
Home
Refresh