Menu
Forum
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Car Audio Discussion
General Car Audio
Car Audio Build Logs
Car Audio Equipment
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Help
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Car Audio Classifieds
Car Audio Wanted
Classifieds Member Feedback
Gallery
New media
New comments
Search media
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Join
Test
Forum
Search
Search titles only
Search titles only
Log in / Join
Search
Search titles only
Search titles only
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Menu
Reply to thread
Forum
Car Audio Help
Wiring, Electrical & Installation
2 Amps installed...Sub amp not pushing enough power!!!
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="bbeljefe" data-source="post: 8219133" data-attributes="member: 655960"><p>Your sub is a dual 4Ω if I'm not mistaken. Correct me if I'm wrong.</p><p></p><p>You said that the Soundstream was driving the sub fine and I would assume you had it bridged to two channels and were running one channel to each coil, which would have been a total of 1000 watts to the sub.</p><p></p><p>So what have you done with the mono block amps? Are the coils on the sub wired in parallel? Series? Are you only using one coil? Are you trying to use two different amplifiers on one sub simultaneously?</p><p></p><p>If you could clear that up, it would help.</p></blockquote><p></p>
[QUOTE="bbeljefe, post: 8219133, member: 655960"] Your sub is a dual 4Ω if I'm not mistaken. Correct me if I'm wrong. You said that the Soundstream was driving the sub fine and I would assume you had it bridged to two channels and were running one channel to each coil, which would have been a total of 1000 watts to the sub. So what have you done with the mono block amps? Are the coils on the sub wired in parallel? Series? Are you only using one coil? Are you trying to use two different amplifiers on one sub simultaneously? If you could clear that up, it would help. [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Help
Wiring, Electrical & Installation
2 Amps installed...Sub amp not pushing enough power!!!
Top
Menu
Home
Refresh