Menu
Forum
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Car Audio Discussion
General Car Audio
Car Audio Build Logs
Car Audio Equipment
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Help
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Car Audio Classifieds
Car Audio Wanted
Classifieds Member Feedback
Gallery
New media
New comments
Search media
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Test
Forum
Search
Search titles only
Search titles only
Log in / Join
Search
Search titles only
Search titles only
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Menu
Reply to thread
Forum
Car Audio Help
Wiring, Electrical & Installation
1999 Lincoln Continental Alpine system upgrade speaker wiring help needed (2.5ohm speakers)
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="Kickstand" data-source="post: 8743165" data-attributes="member: 681842"><p>So you have 2 sets of 6.5's and one set of 6x9's all running at 2.5 or technically 2.7 ohms</p><p>You have a P400-4 Which will do 4x100 @ 2ohms</p><p>And a P200-2 which will do 2x100 @ 2ohms</p><p>So I think your over complicating things</p><p>Just run the 4 6.5's off the 4channel, Don't bridge it. One speaker per channel will give you 2.5 ohms</p><p>And run the 6x9's off the 2 channel, same thing one to each side </p><p>Depending on the HU you might have to use a set of RCA y adapters on one of the Pre outs so you won't have to use the sub out.</p><p>I suggest splitting the front out to run the 4 channel and using the rear strait to the 2 channel</p></blockquote><p></p>
[QUOTE="Kickstand, post: 8743165, member: 681842"] So you have 2 sets of 6.5's and one set of 6x9's all running at 2.5 or technically 2.7 ohms You have a P400-4 Which will do 4x100 @ 2ohms And a P200-2 which will do 2x100 @ 2ohms So I think your over complicating things Just run the 4 6.5's off the 4channel, Don't bridge it. One speaker per channel will give you 2.5 ohms And run the 6x9's off the 2 channel, same thing one to each side Depending on the HU you might have to use a set of RCA y adapters on one of the Pre outs so you won't have to use the sub out. I suggest splitting the front out to run the 4 channel and using the rear strait to the 2 channel [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Help
Wiring, Electrical & Installation
1999 Lincoln Continental Alpine system upgrade speaker wiring help needed (2.5ohm speakers)
Top
Menu
Home
Refresh