Reply to thread

Message: <blockquote data-quote="hispls" data-source="post: 8483040" data-attributes="member: 614752"><p>Pair of 12" HDC3's would be far supperior for you.   I wouldn't attempt to try to make this work with an 18" unless you are very good and have done blow throughs before.  I also suspect that you won't have nearly as much height as you think after you figure in wood and a gasket between cab and bed.  Making sub(s) and port on the same plane will be important and difficult if you need to angle the 18".    Might could do a pair of 15's but I'd bet that'll even be cutting it close.</p></blockquote><p></p>

Top