Menu
Forum
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Gallery
New media
New comments
Search media
Members
Registered members
Current visitors
Classifieds Member Feedback
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Register
Forum
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
Log in / Join
What’s new
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Menu
Reply to thread
Forum
Car Audio Help
Wiring, Electrical & Installation
1200W + 300W amp, what size wire?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="DarrenE46" data-source="post: 547143" data-attributes="member: 556808"><p>Hey everyone, if Im going to run a 1200W Sub amp and a 300W component amp, I was thinking I would run 0 or 2 gauge wire to a cap and then to a distribution block and 4 gauge from there. Is this correct logic or should I be doing something differently? Does anyone know where I can buy these size wires by the foot (the battery is in the back in my bimmer) as well as the installation accesories like ring terminals and distribution blocks?</p><p></p><p>P.S. Im going to be replacing my battery with an Optima.</p><p></p><p>All info is appreciated!</p></blockquote><p></p>
[QUOTE="DarrenE46, post: 547143, member: 556808"] Hey everyone, if Im going to run a 1200W Sub amp and a 300W component amp, I was thinking I would run 0 or 2 gauge wire to a cap and then to a distribution block and 4 gauge from there. Is this correct logic or should I be doing something differently? Does anyone know where I can buy these size wires by the foot (the battery is in the back in my bimmer) as well as the installation accesories like ring terminals and distribution blocks? P.S. Im going to be replacing my battery with an Optima. All info is appreciated! [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Help
Wiring, Electrical & Installation
1200W + 300W amp, what size wire?
Top
Menu
What's new
Forum list
