Menu
Forum
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Gallery
New media
New comments
Search media
Members
Registered members
Current visitors
Classifieds Member Feedback
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Register
Forum
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
Log in / Join
What’s new
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Menu
Reply to thread
Forum
Car Audio Discussion
Amplifiers
100.2 in protection mode why???
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="MyPoison1" data-source="post: 4488251" data-attributes="member: 589644"><p>when I first installed it, it got hot shortly after, not warm but hot. I though that was odd but left it alone. after of being in use for a few hours the next day it went into protection mode. I drove it to a near by shop, they checked it out and told me the amp was damaged, I did not bridged it, I hooked it up to a 10" sd-v1 (400rms) and I only used one channel so I have no idea what caused it to fail. I'm not sure if this amp was refurbished since I got it on sale? anyone know what I did wrong?</p><p></p><p>Thank you</p></blockquote><p></p>
[QUOTE="MyPoison1, post: 4488251, member: 589644"] when I first installed it, it got hot shortly after, not warm but hot. I though that was odd but left it alone. after of being in use for a few hours the next day it went into protection mode. I drove it to a near by shop, they checked it out and told me the amp was damaged, I did not bridged it, I hooked it up to a 10" sd-v1 (400rms) and I only used one channel so I have no idea what caused it to fail. I'm not sure if this amp was refurbished since I got it on sale? anyone know what I did wrong? Thank you [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Discussion
Amplifiers
100.2 in protection mode why???
Top
Menu
What's new
Forum list
