Menu
Forum
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Car Audio Discussion
General Car Audio
Car Audio Build Logs
Car Audio Equipment
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Help
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Car Audio Classifieds
Car Audio Wanted
Classifieds Member Feedback
Gallery
New media
New comments
Search media
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Test
Forum
Search
Search titles only
Search titles only
Log in / Join
Search
Search titles only
Search titles only
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Menu
Reply to thread
Forum
Car Audio Help
Wiring, Electrical & Installation
1/0 ring terminals
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="Beatin&#039;" data-source="post: 8078178" data-attributes="member: 646085"><p>isn't 5/16 good enough? That's like 8mm wide. That seems to be plenty wide. Previously I was using 3/8 terminals and they were too wide for the screws in the car on the positive battery terminal and ground screw in the trunk. I figure 5/16 can't be bad for my application.</p><p></p><p>Is that the only problem with Xscorpion/Bullz?</p><p></p><p>Regarding fitting 2/0 wire in a 1/0 terminal, I was think about fitting the inside strands of wire into the terminal, then wrapping whatever strands left over on the outside of the terminal and wrapping that tight with electrical tape for insulation. Sounds good?</p></blockquote><p></p>
[QUOTE="Beatin', post: 8078178, member: 646085"] isn't 5/16 good enough? That's like 8mm wide. That seems to be plenty wide. Previously I was using 3/8 terminals and they were too wide for the screws in the car on the positive battery terminal and ground screw in the trunk. I figure 5/16 can't be bad for my application. Is that the only problem with Xscorpion/Bullz? Regarding fitting 2/0 wire in a 1/0 terminal, I was think about fitting the inside strands of wire into the terminal, then wrapping whatever strands left over on the outside of the terminal and wrapping that tight with electrical tape for insulation. Sounds good? [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Help
Wiring, Electrical & Installation
1/0 ring terminals
Top
Menu
Home
Refresh