Recent content by wakedreams3

All, I have a Kenwood KTS-MP400MR installed. All audio is going through 2 - Kicker amplifiers (not using head unit amplifier). There is the ability to customize the "System Q" settings...Should I leave this "Flat" and let the amps filter the signal? Thanks

Thank you!

Ok...just got back to this, thanks for the replies I did see a similar procedure that blend the multimeter and "tune by ear" so I am going to start with this: https://www.caraudionow.com/amplifier-tuning-quick-guide-to-tune-your-amp/ Thoughts?

Thanks for the reply, I have set the gain at 35-40% (below 50%)...I have run the system at the highest level I will run it at and it will clip. I have backed the gain down from 40% it's operated better but still clips. Any advice on setting the gains properly would be great.

All, I have a Kicker ZX250.2 amp powering 4 - KM620.2 drivers with seperate tweeters. (If you count the drivers and tweeters there are effectively 8 speakers) Essentially the original install has 2 speakers going to each channel of the amp. My amp continues to clip out (protection light...