Recent content by tyranis

  1. T

    Bending Slot Port

    Ok, when you "bend" the port you need the average length. so if you used a 14.6x2x15L port you need to subtract the width (2") from the port. Since it is also (I assume) using an outer box wall as a port wall, you need to subtract 1/2 the width from the port also (another 1" in this case). I...
  2. T

    speaker wire size

    Look for some Kimber Kable black pearl series. Or buy a new motorcycle! LOL used to be several thousand, exotic audiophile speaker wire.
  3. T

    Why 4 awg power, and 16awg speaker wire?

    amp output cant be 110volt, if it was and you held the spkr wires, and got even close to 10 amps, you woud die of electrocution. higher current/amperage does need larger wire. I have 4 ga power wire and am going to double run 12 ga or find some 10 ga wire.
  4. T

    port placement & box advice 15XXX

    ****, what do you have in the competition box? Any thoughts on where to place the port? near sub or sub on left, port on right, sub in middle, port on right, etc. thanks a lot Jim
  5. T

    port placement & box advice 15XXX

    I have 15" RE XXX in my Focus ZX-3. 2400rms to it. I am going to build a new box for it. It will be 35" wide up to 20" tall and up to 20" deep. I have 3 4" aeroports. And a lot of questions. Car is daily driver, non competition. Plan to tune to 33hz, good freq and fs of driver. I plan...
  6. T

    any ford focus out there?

    Also upgrade you ground wires, I added a 8ga to the bracket over the alternator, and a 1 gauge from the batt to the shock tower, and scraped off paint to get good connection. I put amp under pass seat, to shorten power wire length.
  7. T

    any ford focus out there?

    just because your lights dim, does not mean you have to have a new altenator. My lights dimmed with my PPI A600 (uses 1 40A fuse) when used it for bass. My lights dimmed more with lanzar vibe 1200. They dim even more with the M3000D 4x40A fuses. I still get by. I play loud for long time...
  8. T

    suggest any comp speakers?

    I went and (recommend you do the same) listened to everything I could at all local stores, I always made the salesmen make the eq flat. I found a good steep and low xover point made a big diff. I like no higher than 4.5k, prefer 3k. See which you like the best between metal and fabric tweets...
  9. T

    XXX in the rec. ported enclosure

    Once you hear it ported, you will not go back to sealed. tune @ 35 in 3 ft with at least 4ft aeo port and you will like it!
Top