Recent content by Tucsonboy

The amp I returned was a hifonics Brutus. If you go to the close outs section 90% of the amps are refurbished hifonics. Have a bad taste with those amps.

just returned my amp to sonic electronic. I have a 180 credit towards a new amp. I needed it to do Around 500 rms at 4 ohm and Around 1300 at 1 ohm. The two I'm looking at are pioneer gm-d9601 or massive audio n3 nano or willing to hear other opinions. I don't want to go north of 250 total...

I'm building my system focusing on sq. the ppl at soundqubed recommended this line in a sealed enclosure. Thanks for the offer but I'm going to follow their lead. Any thoughts on my original question?

Just bought a soundqubed hds 2-12. After speaking to support, I need a 2.3 cubed sealed box. I haven't found anyone that makes this without it being a special order. However I have seen a lot of dual boxes with this capacity. Do u think I could get away with breaking the space separator and...

I was already thinking about the soundqubed. Someone pm me about treo see. I am unfamiliar with them. Any thoughts?

I have always heard that sealed are better for sq. from what I understand the soundqubed are made for ported which isn't a deal breaker.

Hello, I have an amp that produces 600 rms at 4 ohm, 1200@2 and 1600@1 ohm. Looking for a sub to match to this in the 150 to 200 range. Prefer quality over loudness however, it is going into a convertible so loudness is important. Also am I better off with 2 subs at the 600 rms level or 1 at...

@trumpet That looks similar to what I had in my head. Basically I was thinking of a modern jbl gtx47. What can the dsp things compare to that?

@nutdawg I already have the amps so it would be cheaper to by the crossover than a new 5 channel amp. @trumpet I would say mid level. I have installed all the wiring on my car. I usually have the speakers installed professionally but that is more for aesthetics of the car. This is going into...

I am looking for an active crossover so I can run a tri amp system. I thought it would be a 3 way but most don't have the outputs I need. Can someone help me in defining what I am looking for? Set up I want: Head unit Crossover 3 amps 1 30 to 40 rms 4 channel for all the tweeters ( no...