Recent content by tr3nt

From what I've indicated, does it sound like my amp is dead though?

http://img.photobucket.com/albums/v602/tr3nt/20130615_165914_zpsed4e2a4c.jpg http://smg.photobucket.com/user/tr3nt/media/20130615_165854_zps22bb81d6.jpg

This is the subwoofer setup: 2 X 12" 600W Clarion Subs IN BOX With 2 Amps AND Wires Quick Sale PLZ Offer | eBay (without the sticker on the front) I have just checked the ohms and one is pulling 128-132, the other pulling around 68-72 or thereabouts, which doesnt seem right obviously.

Hey buddy, this is where I get a bit confused. im unsure on what final ohm load, this was with the volume at a quiet-ish level playing an everyday chart song. how do I check the final ohm load? The amp im using is this model: Amplifiers - Mono - Cadence XA-400.1 850W Mono Amplifier - Car Audio...

I just hooked up a multimeter to the amp, on the speaker wire outputs, and they're reading around 45 volts or so. im unsure if thats right or not :s ?

I can check with a multi-meter, I have access to one, however not until the weekend. It's just odd that one day it was working fine, then the next its not - yet the unit will power up.

NIHL8ION: for memory I would have had the gain set around half way. I dont recall ever having any of my amps on gains further than halfway. Do you have any idea's as to why the amp would power, not show any lights (apart from the blue Cadence logo), but not provide signal through the speaker...

Hi guys. Roughly 12 months ago, I had a Clarion twin 12" sub setup run from a Cadence monoblock (XA 400.1). This ran beautifully, however I did notice that if i had it cranked for more than maybe 45mins-hour, it would cut out, I figured the amp was getting too hot.. I'd shut it off for 10-15...