Recent content by timpact14

cool, thx man i like this program better

r u talking abt the port pieces cut @ a 45 degree?

this is what i came up with..what do u guys think? http://www.subwoofertools.com/forum/ported-box.asp?Ew=25.00&Eh=16&Dia=6&Xmax=18.1&Vd=.071&NumW=1&Vb=2.0&Fb=32&Qts=&Vas=&Fs=&CE=0

oops! i meant ported. let me give this program i try

running 1 1222d @ abt 500w rms in a 1990 chevy blazer. im limited in the space, i have abt 26"w(max) x 14 - 16"h x 14 - 16"d. looking to tune it to abt 30-32hz with abt 1.6 to 1.8 cuft....the plan below is almost perfect, if i can figure out how to make the width to abt 25.5" and keep the cuft...

anyone have any info/opinions on this battery?went to my local sears looking for an optima yellowtop..they are out & wont sell them anymore i was offered the new Diehard Platinum battery. it has 880cca & 130min reserve its priced @ $170. its not a deep cycle batt...i mainly drive while...

anyone?...could it be that its nt getting at least 12volts?

each tweeter & sub show 3ohms each but they are rated @ 4ohms & figured the xover compensated to for ohms.. i did forget to mention the it plays fine at low level with no clipping but when turned up goes into protect.

im running a fosgate p450.4..trying to push some alpine type x's and some mtx mids..both of these components are rated at 4ohms..@half gain the amp goes in to protect mode when the type x's are hooked up, but does nt do it for the mtx's..the type x's do require a bit more power but @ 4ohms the...

need help on this dilemma that i have re: dash speakers... the car is a full size blazer k5. The doors, floor have all been treated to dynamat(looking for sql)...this is what i currently have in plan.. *alpine 9856 HU *Polk SR6500 doors pwrd by fosgate 450.4(its rated @ 60rms 4ohms..but it...

i thought abt it...i knw i have lots of room inthere. other than the dynamat, what would be good to make an enclosure out of?

where did u buy yours from? theres no dealer out here in PhX..

this is the only part # i found for my 90k5 blazer-QL-K1006B01. it says fits only up to 6-1/8":confused:

what r u asking for them..

sorry guys... yes, im looking for a dedicated midbass only... you can mod the Qforms. also, they have new ones for this year that fit 6 1/2's. still need to deaden and stiffen the heck out of them for a beefy mid bass driver. vent it so it isn't a small sealed enclosure, and don't allow the...