Recent content by threedd97

  1. threedd97

    WTB: 06 XXX 12" or 15"

    Looking to buy an 06 XXX 12" or 15". PM me what you have with an asking price please.
  2. threedd97

    Explain how the output of this particular amp works.

    http://www.soundstream.com/amplifiers-picasso.htm RMS @ 4 Ohms 1800x1 RMS @ 2 Ohms 2500x1 RMS @ 4 Ohms Mono 3500x1 What is the difference between "RMS @ 4 Ohms" and "RMS @ 4 Ohms Mono"?
  3. threedd97

    Incriminator Audio VS MA audio

    If you know so much, as you are trying to insinuate, then I'm sure you can decide on your own what amplifier to get for your setup. To us, the way you have been talking, you don't know anything about what you are trying to do.
  4. threedd97

    whats the legal noise level in your area??

    Where in MS are you from? Down here in Biloxi it's pretty lenient. I've never been pulled over for DTP or any other sort of noise violation. That was with my 15" XXX and Cadence ZRS-8. I am currently working on getting my '06 XXX 12" and ZRS-10 bought up and shipped to me so I can set it all up.
  5. threedd97

    First Post

    What's with the Type-R hype?
  6. threedd97

    how do you power your subs

    I get adjusted to the sub pretty quickly and find myself nearly maxing out the volume most of the time, so yes, I can say that I do.
  7. threedd97

    how do you power your subs

    I did have a 1600w RMS sub with about 1800w on it. My new setup will be a 2000w RMS sub with around 2800-3000w on it.
  8. threedd97

    Am I going to fry my subs ??

    No, L7's can take a beating. Aside from that, your LPF should not be set all the way down. If you turned it up to around 80hz or in that general area you'll find you can turn the gain down on the amp as you are opening up the range for the sub.
  9. threedd97

    Help sub doesnt sound the same

    Mine told me 1600w and that the DVC is 800w per coil.
  10. threedd97

    Help sub doesnt sound the same

    Are you positive you have it bridged properly? With the pos and neg wire on the outside pos and the outside neg on the amp?
  11. threedd97

    Help sub doesnt sound the same

    "Breaking in" just gives a fuller sound, possibly a bit louder. You're using an xover on the sub? Why? Gain is up doesn't tell me much, don't use the punch bass if you don't have to. It is a bass boost and can only cause distortion and/or clipping. Um... what is the impedance of your sub (ohms)...
  12. threedd97

    Well i have a new stereo prodject

    It's super humid here on the coast and my XXX 15" started rusting all over the nickel plate that was on the bottom of the sub below the magnet.
  13. threedd97

    Explain This

    http://www.knukonceptz.com/productDetail.cfm?prodID=FH-20 Badass one for $19.99. And you get a free ANL fuse of your choice.
  14. threedd97

    is this right? (ohms)

    What amplifier do you have?
Top