Recent content by thechris

i see what u mean ... that really sucks then ...

so i would wired them up either 2 ohms stereo ... or 4 ohms bridged mono ... not 1 ohm mono

amp is 2 ohms stereo stable 4 ohms mono stable

...subs are crossfire p1 12's dvc (4 ohms per coil) ...amp lanzar vibe 250 2x250@4 ohms 2 x450@2 ohms 1x900@4 ohms bridge (bs specs) either way i wire them up 2 channel or bridge it still would go into protection ... when it hits low freq. at high volumes ... i read on another forum...

sent message ... AMPLIFIER GOES INTO PROTECTION WHEN I HIT LOW FREQ. AT HIGH VOLUMES ... HOW WOULD I ELIMINATE THIS PROBLEM...THANKS .... ???WOULD A CROSSOVER HELP??? reply... support@lanzar.com | This is spam | Add to Address Book To: "CHRISTOPHER OCAMPO" Subject: Re: VIBE 250 Date...

im using 4 ga. and i know its not the gain ... its all the way down ... im just using bass boost ... or i would set it 1/3 and bass boost off ... still same problem ... stupid amp ... amp is pissing me off ... i should have gotten the opti ... or better yet .... go crossfire ...

hey i havent tried that yet ... i'll do that and see what happens ...

this **** amp goes into protection when it hits low freq at high volume...how would i be able to eliminate this problem ...

im running them series/parallel ... i know they are at 4ohms at the wire cause i checked at least 15 different times ... crossfire p1 dvc (4 ohms each coil)

hey im new to this forum so i just want to say whats up and say many thank yous for having such a forum ... here is my problem ... im running two crossfire p1 dvc to a lanzar vibe 250 amplifier at 4 ohms mono ... the **** amplifier goes to protection when i crank it up ... whats up with that ...