Recent content by swizz977

ok so my jl amp low voltage light is on ive had the same wiring for years everything was working fine until now im thinking its eather my kinetic battery, the amp, or the head unit? heres a picture of my install.. im going to take out the battery and see if it works better

what controls the lower bass on this amp i want to turn it up a little

have any of u guys heard of volume adjust on ur hu it can go to +5 and its like a gain for the volume and the volume is still 0-50 wud u put that up

and theres my answer thanks now i understand

yea i did all that

did i do it right??

ok i got .840 by touching the red inside and the black outside playin the test tone what does that mean

i tried testing my hu output but im not getting any reading except like .060 im not sure if im doing it right

i have the bass at 0 and the loud turned off on my hu when i set the gains

even if the gain is almost all the way up on high and very low at low?!

actually if you read wat i wrote when its on low my gain is like 30 percent on high its like 80 percent

this is step 8 on how to set ur gains Increase the input sensitivity control until the desired voltage (determined in Step 5) is delivered. If multiple subwoofer amps are being used, set each one to the same exact voltage and you have also level matched them. If excessive voltage is read with...

this is my head unit Amplifier KD-R900 Maximum Power Output 50W x 4 Continuous Power Output (RMS) (CEA-2006 Compliant) 20W RMS x 4CH at 4 ohms and no more than 1.0% THD + N MOS-FET Amplifier Yes Audio DAC TI/Burr-Brown 24-bit DAC Yes Source-Specific Volume Control Yes Volume...

he also said the low is for aftermarket hu n the high is for stock idk man u call him

well the guy from jl said ill get more signal and better voltage on the low setting