Recent content by surferboricua

Per the manufacturer: Max. Input Voltage: 80Vpp（x1 probe）400Vpp(x10 probe) I just went ahead and divided by two, but it would be 28.280 Vrms (x1 probe) and 141.400 Vrms (x10 probe) Yes sir.

I bought one of these but V3 last week and I can tell you I really enjoyed using it for setting my car audio's gain. My current setup consists of head unit, loc, eq/linedriver, and amps. I used it to set max volume on head unit and gains on each of the other devices all the way to the amps...

I will have to find a Line Output Converter that doesnt divide my headunits output voltage which is at 6 volts at speaker level to 2 volts at low level RCA and gives me some more voltage.

Ive been reading on matching head unit pre amp out to input sensitivity on the amp in order to be able to bring amp to its max output. I forgot to mention the amp has two selections for input sensitivity: from .02V to 2V and from 3V to 8V. My preamp/EQ/line driver has my output to subwoofer...

No, it is not a ported enclosure. Its a closed one...

What is a good amp I could use for my 12 sub? It is rated 350w rms 4 ohms.

Lol... thanks all for your answers. This Subwoofer is SVC, but the one I previously had was a DVC 4ohm wired in parallel to 2 ohm so I was able to pull more out of the amp. I dont know how many watts it was putting out back then because right when I blew that DVC is when I started reading and...

This issue has been bugging me for a couple of days. And i've been reading and searching high and low but havent found a definitive answer... Heres my setup and my problem. My problem is I bought a new 12' Audiopipe subwoofer 4 ohms and rated at 350w RMS, I hooked it up and with my volume all...