Recent content by subarugeek

so just so i can make sure im understanding this correctly. If i get a Dual 4ohm sub and wire each coil to one channel, the amp will output at 2ohms? Correct?

Ah, lack of a common ground. Check where and how your alternator/engine is grounded and if nothing else, extend multiple grounds to the chassis. Installing two way radios I encounter similar problems... Hope this helps alittle bit.

what would the output of the amp be with this setup? Would I just be better off going with a Dual 4 ohm Type R, and wiring each coil to one channel? Thanks much!

Okay, but if i were to bridge the two channels in to one, (the amp is rated at 560w mono RMS) then how would i wire the single sub to get the most out of it... what impedence would it be at... Im very very appreciative of your help! Link to amp: (Ts980-2)...

Hey guys, Im either stupid or my...well, maybe thats it. I just purchased a Alpine 12" Type R Dual 2ohm voice coil sub. I also purchased a power acoustik 2 channel, 260watt per channel @ 2ohm amp. As my previous audio experience had led me to believe, if i were to wire one voice coil to one...