Recent content by Streetz

Thanks for your reply... The ground is very good, moved to a new spot at the bottom of my trunk. Used sandpaper and got all the paint off, good connection there. Both ground and positive wires are 4 gauge, biggest the amp can take, so maybe a cap is needed. When I tried a second set of RCAs...

I'm actually unsure if it's the amp, headunit or subwoofers... I recently just installed a new subwoofer setup (2 RF P3D412, a Profile AP2000 amplifier and a custom vent box). For about a week everything worked fine, than the subwoofers have a constant humming sound coming out of them. When...

Bad subwoofer maybe? I had the same issue, everytime it hit a certain volume my amp would cut off and go into protection mode. Ended up being one of my subwoofers was dead. Just a thought. If the subwoofer is fine, try rewiring without a switch, certainly could be the issue.

They do tend to be purdy

LOL, thanks for the input. Oddly, just taping it never even crossed my mind.

Nope

I had to rewire my car, originally I had it going through the door jam because I didn't want to bother with the firewall. Everytime I open and closed the door in would pinch the cable and it started to frey(sp?). So I rewired it correctly, going through the firewall to the trunk. The positive...

So according to that wiring diagram wizard, I can do the following wiring series to get an 8 ohm load: and it will be fine connected as the bridged 4ohm stable on the amp?

I'll take a look at that and thanks

I'll try to keep this short, but have a dilemma: First, I've never dealt with DVC subwoofers before, and right now very confused. I bought an amplifier (Profile AP2000) for a pair of subs I have (which I found out a week ago one is blown). Now the amplifier can have the following setup: -320...