Recent content by Stevenajpvv

4800 under the hood all the way

Glad I saw this. I own both the 4800 AND 3400 and I gotta say these things perform. I have the 4800 under my hood and the 3400 back by the amp. Im running a 3k, 400x4, and a 150x2. My suv charges at 14.4-14.5 and I dont drop below 14.0 full tilt (unless playing a sine wave then lowest ive seen...

Just ordered the pipe xover! Shipping out tomorrow. Nendos back in stock and shipped. Cant wait to get it all setup

Will the following work for what I need, XV-4XP - 3-Way Crossover I think it will, and i might as well run my sub out through it too .. Is there something different I have to do now wen setting my gains with this installed? Is there a gain on it i need to set also? (I have my brothers dd1 so...

And turn off my radios filters and crossovers ^

Ok makes sense so front and rear rca from unit to crossover, set my 4 channels switch to 2 channel then run the rear off the crossover to 4 channel and front off the crossover to my 2 channel. Set bandpass's accordingly and say **** you to the passives. Set amps crossover to ap on both. Is that...

(Previous reply) thats how to do it to work without doing what i drew i think?

Ill be using the included xovers for the rts's.

I really want to keep and use the amps I have, and i just saw that ap is the exact opposite of bandpass filter...so now im thinking that i need to go active unless theres a different way? Since every speaker is on its ownn channel active should be easier and the better choice vs. 4 passives one...

Hp, Lp, and Ap, is ap wat i need?

My 4 channel is a RF r400-4d. I believe its capable but i could be mistaken. Would you mind checking it out? Greatly appreciated

So what you are saying is wire 2 together per channel on my 2chan each on its own crossover, correct? The another question i have is, running my pwx's 1 per channel on my 4 chan, how do I set it up so it plays the frequencies it is supposed to play and not what i want my tweets to play?

Just looked online it says 4v... Looked in the manual says 8v I guess I got a typod booklet but appreciate the reply

Hey guys quick question. My hu has 8v preouts (avh-4000nex) and my American bass amp for my subs is able to be set up at 8v. Here's my problem, my Fosgate 4 chan. And 2 chan are both 4v maximum... How can I get maximum output out of all three? I have a dmm and dd1 so setting gains and checking...

Alright cool man thanks!