Recent content by Spudnic

It does come with a good length of wire and rca but under the seat wouldnt work, not quite thatmuch wire. Behind the glove box is where i was able to fit it, my glove box has slight issues closing but i think i might be able to just move it around alittle back there and all should be good

for 100$ assuming everything works on it, and its not stolen sounds like a good deal. Even if it is stolen, might be worth it ~.O

Installed the D1305 the other night. I like it sofar, def a nice starter deck. Has EQ settings, only cons is that i wish it would play my music while viewing the navigation map, however it will play the navigation dialogue over the music which i found wierd that it wont do the oposite. Pretty...

Some of the newer decks have gyroscopes that will detect if the car is actually in motion or not, not sure if this is the case with yours. try grounding like the guy above me said and if that doesnt work you can put in a switch and ground one end of the switch and connect the green or pink wire...

pickedup the d1305. pics once its instaled

there actually the same company? haha thats funny ok thx

Can anyone tell me any Differences between the; Soundstream VIR-8310NRB and the; Eonon D1305 Other than the .3" size difference in the screen? I'm just not seeing any difference Between the two. Think ive pretty much settled it down to one of these two HU's though.

any ideas where i could get a plug that matches it? would rather not clip off factory stuuff.

#1 Iso port?

That Eon D1305 has a Iso port on its harness, not exactly sure thats all about and was hoping somone could explain to me how ide go about installing it?

huh?

Looking into getting a single din Touch Screen Deck for my Sable(lol). Gunna replace a old kenwood i got, kenwood works great i just am getting alittle bored with it. Things im looking for; Cost effective, around or less than 500$ Navigation, Either built in or with function to add navigation...

Thanks everyone for your help. Turns out i friend the Rem on the deck but re wired to switch and worked fine.

Ive got a DMM im gunna use on the Rem tommorow so i should be able to determine with it whether the HU is sending a signal or not. When you say "rem is bad" and "HU not sending any signal" what is the difference? Do you mean the actual Rem terminal on the amp when you refer to Rem?

I tested the rem when it first happened and got no light but im hoping i did something wrong testing it. gunna try that jump and hopefully it works and ill just switch the rem to the red switched on the deck harness. Thanks everyone for serious answers!