Recent content by spencer321

I really appreciate it but I have this thing about doing it myself or not at all lol not talking about evan by any chance are you?

Technically it should take twice as much resin but its a long panel so 4 layers of 1.5 or 2 layers of 3 should be the same, I appreciate it guys, going to give the 3oz stuff a shot, if I find it unbearable to work with at least I should figure it out in the mold stage and not have to ruin a...

Putting some silverflute 8s in my crown vic doors, replacing rsd6.5 mids

Putting some silverflute 8s in my crown vic doors, replacing rsd6.5 mids

posting "builds" I get too involved and forget to pick up a camera but ill try to make a decent build thread. Im not so much worried about weight as flexibility. If 3oz is that heavy duty I can do 2 layers and be done im just concerned with how workable it is, if it doesn't conform or bend...

Got a new car, have to remake door pods, ive done doorpods before but the door was flat so I had a MDF back plate. New doors are not flat but have a nice cavity to get a backing mold from. Local marine store only carries 3oz chopped mat, most tutorials ive seen say to use 1.5oz, Im curious if...

nevermind, should have read the thread

yeah i opened it up, didn't see anything burnt, i looked over every part of it very carefully but i also don't know what im doing, i just looked for burnt spots or broken solder connections and didn't see any

no its the amp... i started workin on it, been disconnected for a few days, now it goes straight into protect, so i disconnected everything and hooked it straight to the battery and jumped the remote to the positive, straight into protect... so i opened up the back of it... what am i looking...

checked the power and ground... its steady, plus my highs amp is off the same distro block one foot away and that amp is perfectly fine. Pulled the sub, Dual 4ohm coils read 3.9 on each coil, checked and double checked all my wiring, it all seems fine, the only thing i haven't gone through is...

so anyone familiar with the subwoofer in question?

ok, well once again, the question was from A... to B... now 90% of ppl here are familiar with the value of the audioque... if someone was to respond to this particular thread, it would be nice if they were also familiar with the PC18... considering that is the question at hand, and if they were...

why must you be so far away! not lookin for any kinda trade by chance are ya?

no **** sparky, you point me where i can get one for 250$ and i'm all over it, or for that matter, if you can show me where i can get a nightshade, death penalty, dc level 5, or hell even an xcon 18 in a straight up trade for a hdc312 than by all means show me the way. I've been doing this for a...

anyone have any experience with these subs, i just figure going from a 12 to an 18, its gotta be louder, but i've had an itch to go bigger for a long time so i don't wanna jump the gone on some garbarge that i'll never be able to get rid of