Recent content by soulstace

  1. soulstace

    $15 sub

    I bet you'd get a lot more SPL from 10 of these than you would from a single $160 10" sub. lol it's sad how expensive most subs are. All of them should be this cheap (at least the ones mass produced on assembly lines anyways...)
  2. soulstace

    amp for 15" MTX 9500?

    Just curious. What makes you so sure it can handle more than 600W rms? Boondock Saints.. Good movie. And btw, nice azz! lol
  3. soulstace

    4 ohm load or 1 ohm load?

    But it does affect efficiency, correct? By that I mean lower impedence has more efficiency, and higher impedence has less efficiency.
  4. soulstace

    Help!!!!

    I put thermal compound inside my amp (where it mounts to the heatsink) after I repaired it. Although it never seemed to get hot anyways. I think it has something to do with the fact that it is digital amp.
  5. soulstace

    4 ohm load or 1 ohm load?

    Thanks for clearing that up for me guys. I'm sure it will help the original poster as well.
  6. soulstace

    1 ohm stable amp not holding 1 ohm load

    edit - sorry I misunderstood your post, nevermind.
  7. soulstace

    4 ohm load or 1 ohm load?

    gotcha So what's the big deal about clipped and/or distorted signal if it isn't gonna hurt the sub? Is all that it affects is sound quality or does it actually make it easier to destroy the sub as well?
  8. soulstace

    4 ohm load or 1 ohm load?

    But isn't it possible to get terribly clipped and distorted signal even with very small wattage output signal?
  9. soulstace

    Blown amp help

    When installing the amp you should always be careful with hot wires from the battery. Preferrably disconnect the negative terminal of the battery before doing any major work. Also another reason amps might blow is because of speaker wires shorting out, or speakers having too low of an...
  10. soulstace

    4 ohm load or 1 ohm load?

    Thanks DK, but I wasn't referring to RMS (continuous) wattage. I was referring to minimum wattage. Apparently minimum wattage is "the absolute bare minimum wattage required to get acceptable sound from the subwoofer". I was always told that too low wattage could damage the speaker as well...
  11. soulstace

    4 ohm load or 1 ohm load?

    Then whats the purpose of minimum wattage rating on a sub? I'm not saying you're wrong, just asking.. Thanks.
  12. soulstace

    Class A/B vs. Class D power for Subs

    mmats At full capacity it will most likely not be 90% though. So you're mostly right.
  13. soulstace

    Class A/B vs. Class D power for Subs

    I have. I own one.
  14. soulstace

    Class A/B vs. Class D power for Subs

    Some class D are up to (or over) 90% efficient.
  15. soulstace

    sub not as loud as use to be..

    Roll your eyes all you want. If you didn't want to get pwned then you shouldn't have told me to "stfu nub". Or in terms a child your age would probably understand, "You started it".
Top