Recent content by snowcruizer713

i did also happen to blow a type x when i first installled them, couldnt that mayb have damage the amp not allowing it to put out very good output

wouldnt that jus make them quieter

wow so ok, ran jsut runs sub off the amp and it slapped like it should, wired up 2 2ohms and the amp supposedly puts out 1700 watts, so should i not even bother wiring them 2 gether and jus run 2 1000w rms amps

wat u mean electrical system, like all of the wiring from battery 2 amp or jus how the subs are wired?

hmmm, wat kind of amp r people usually running, the guy i bot the subs off of was running to alpine amps, running 450w at each sub. wat bout like a hifonics 2000w amp

checked them seperately and and 2gether, they both read 2 ohms and a combined 1 ohms, i guess i can try and read how much the amp actually puts out

grounds fine, ive previously ran 3 different setups and they all worked perfectly fine

yea may build a new box, but as far as quality ofthe box this is good. yea the hcca was hitting real well, stayin tight on notes and gets loud, this 1 sounds like its bein way under powered when like i said my friends r's were hittin real hard and clean. amps the bamf 4000/1d, even tho it wont...

nah rca are in the proper spot, didnt change anything jus swapped out my orion hcca for the x's

checked all my connections and settings, seems like the subs will only take like 200w, box should b built fine 2 the x's shouldnt it btw the box is 2 ported boxes put together

i got 2 12" alpine type x's wired 2 1ohm in a 3 cubic ft. ground shaker ported box. im running a power acoustik 4000w amp and my subs arent hitting hard at all. at 1` ohm the amp "supposedly" puts out 2200w rms. alpine states that for maximum results run the sub in a 1.4 cubic ft box. my friend...