Recent content by Snodude69

ya, it's a foam bed. it's awesome.

I have a 10" mtx 8000 runnin off a kenwood 800. My original plan was to put the sub in the middle of the box facing upwards, likein the narrow spot but i figured that wouldn't work very good if at all. I'm not very good at building boxes so if u have any idea for a box that is those dimension...

That's the top view, the front view is 9" high by 4 feet wide with the beer slot fit into it.

so can someone help me with the design?

The problem is, i built a box before, and it doesn't sound all that great. i'm not sure wat i want it tuned to, i listen to rap mostly so somewhere in the 30hz range but i also listen to alot of metallica. And yes, those are the dimensions i have to work with, those are the maximum size the of...

Does anyone have any opinions or anything, i need to know where to put the sub and the port if i put one in, also i need to kno how big to make the port? if anyone can help me with any of this, or just give me your general opinion.

Hey boys, im makin a new box for my mtx 8000 that will fit under the bed in my van, these are the optimum measurements in the pic. i want to make the ports and such arounds those measurements, i can change them if necesarry, there the maximum everything can be.

so i want it to be set on LPF then. it's got a swtich to turn it to LPF and i think it had a little knob to adjust it too. Wat should i adjust it to? sorry i have so many questions, i just dont wanna blow my sub up. Also, my final question, do i want it on mono or stereo mode?

How do you think my thunder 8000 would sound in my van in a triangular box. i can't decide whether i wanna build a box and put it under the bed, or if i should put it in the corner in a nice lookin triangular box.

i have a ported box tuned to 35hz or soemthing real close to that

Wat's LPf and HPF do. also wat is input sensitivity?

Any Help Please

Hey there everyone, i just aquired a kenwood KAC-7251 amp from a friend, It is rated at 460 watts bridged at two ohms with 14.4v. I'm gonna run my MTX thunder 8000 off it, it's dvc 4ohm when wired in parallel presents a 2 ohm load. My question is, what should i run my amp at for the LPF...

Well 2thunder 8000's wired with coils and speakers wired in parallel presents a 1 ohm load. i do brelieve there 4 ohm subs

how do u plan on wiring ur subs?