Recent content by SMIRK

Thanks for the input. I did a little more research on monoblock amps and think I have a better understanding. I will be running the amp bridged which will leave it at 500w RMS @4 ohm.

Semantics, let me rephrase it! Each amp has two output terminals. If I ran one +- terminal to one voice coil and the other +- to the other voice coil; how would this convert to watts and ohms? Would it convert the same as running one set of wires to the speaker and then wiring the voice coils...

My apologies if that was confusing. The amps are referred to as monoblock in the respect that they internally turn the stereo input into 2 mono outputs. The amps each have a left and right output that put out the same audible mono signal.

Yes, the amps are monoblock. The subs are duel voice coil so, I believe I have the option of running the voice coils in series or parallel which would change the impedance.

I will be running two MTX D8100 amps into two Kicker Solo Baric L7's (2 ohm duel voice coil). What would be the best way to wire the amps to the subs? The amps are rated at 1000w RMS X1 into a 2 ohm load or 500w RMS X1 into a 4 ohm load. The speakers are rated at 750w RMS or 1500w peak. If I...