Recent content by Sliced

ya... i guess if they sound really close in quality then there's no point to spend more than i need to... that's what i m wondering... how noticeable is the difference you think? worth the extra dole? thanks...

i m looking for some clean power to drive the front components... and these have similar rms ratings... what's your take on the SQ? thanks.... Audiobahn A2601Q (150X2) Hifonics Z6000 (150x2) JL 300/2 (150x2) I tried the Jl locally and i liked it a lot... wondering how the other two...

i had Infinity reference 605cs in my ride front door the first two years, i liked it a lot. They performed very well even after two years of 150rms abuse. They sounded way better than speakers in most of my friend's ride. the only complaints i had was the tweeter being distorted very...

How would you choose? both have similar rms power... alpine stated a 0.08% THD while JL has a 0.03%... is this noticeable? I m driving a pair of Focal 136v 5.25'' both looks dope... and later on when i have a bit more money i m plannin on a matching sub amp as well...(MRV 500 / JL 500.1) so i...

Awesome guys... very educating, so in short, lower volume levels corresponds to lower wattage output from the amps and thus, not feeding the sub at its rated power and thus the sub should not break .. (provided, yes, the gain was set properly, and it's a clean signal... right?) somewhat...

ah, sorry typo, i meant 500W into 4ohm as well... basically, same power (500W) into high / low sub resistance... would that make a difference? :p

any one has opinions on these two issues? 1. A sub, 2Ohm, powered by an amp that plays 500W @ 2ohm should sound the same as a 4ohm sub powered by an amp that do 500W @ 4Ohm right? 2. Which of these config would break? pumping 500W clean rms into a sub that handles 800W rms, vs pumping 500W...