Recent content by SkrillaPyles

Na the 10w3v2 has a big JL logo in center of speaker

Yeah I installed them myself and nothing jumped out at me being totally different from the other. I would pull them out and look back of sub but I place foam mounting tape between sub an box for better seal so that's gonna be hard

I have 2 jl 10w3s but 1 of them has a "w3" logo on front but the other one had a "JL" logo. Can anybody tell me why?

I have 2 jl 10w3s but 1 of them has a "w3" logo on front but the other one had a "JL" logo

The p3 is a 2 ohm dvc so i could run it parallel to 1 or in series to 4. The kenwood amp says it does 500 rms at 4ohms I have also accumulated alot more stuff now. The total list is. Amps; Kenwood 9104d ,audiopipe ampi-1300, massive 1200d, jl j2 320.4. : subwoofers; 2 12in fosgate p3s (2...

If i was just going to run 1 sub, why the **** would i choose the PA over the RF

BTW It's a regular P3 not a shallow. 500rms 1000 peak

What does that even mean

100 for the pair I'm going to be putting them in seperate boxes then on top of 12s in back of my suv

I need 6x9 suggestions under 100$ ( in seperate boxes) will be hooking to a 300.1 rockford fosgate a/b amp

I know how to calculate the resistance if each voice coil is the same. But for some reason I was thinking you also had to divide it by # of subs as well then also using the wrong formula, I did not know how to do it with voice coils of seperate resistance. That's why I'm asking. I wasn't saying...

Yes I know that. How bout if I ran both speakers parallel. That you be 2+2+4+4=12 12÷2=6 then 6÷4=1.5 ohms, if the subs can withstand a 1 ohm load , how come I cant run a 1.5 ohm load?

Why not.

I have a kenwood 9104d amp. I did some research on it and it says it does 900 rms at 2 ohms and is regulated down to a lil over 900 at 1 ohm .I had dual 12 punch p3s (2ohm) and wound up blowing 1 of them. my friend gave me a power acoustic gothic. It's a 4ohm dvc. I know it's not good to have...