Recent content by sentrazack

Got it squared away, i think the filters moved while installing. I adjusted them and it seems to have solved it, thanks again!

Thanks for help guys, So should the amp be in the off position for hpf and lpf? Its been a while since ive hooked this stuff up so i apologize for the dumb questions. ha ha That all makes sense to me now, but why would the tweeters be almost silent?

Hey guys, Heres my issue, I installed my CDT components and am getting very faint sound from the tweeters. The music plays, but all from the mid (shouldnt the mid be just midbass and no voices?). I double checked my connections and they all look good. It does this on both left and right...

Just an update in case anyone comes across this in the future. I narrowed it down to the RCAs and decided to run a seperate set to the back and that seemed to fix the issue. The RCAs I was originally tapping were for the sub (in mono) which is why only the mids were workin and not the tweets...

Ok I think Im makin some headway. I re-did my ground and now it appears that the mids are workin fine but the tweeters still dont work, all I get from them is a very faint static sound. All connections to crossover are secure and solid. Any ideas?

BlackBonnie, thanks for your help. Ill double check my connections tomorrow morning and see if I have better luck. Ill let you know what I come up with. Thanks again

Thanks! Where do you think is the most likely wiring culprit? Fuse? ground? Like I said the amp turns on and sends power out of the terminals, but I get nothing. Thanks for the reply. Any other ideas?

Hey guys, just installed my new CDT CL-61A components w/ profile AP1000 amp. Ive got everything wired up and its correct (went over it 5 times). The amp has power and RCAs are good. I checked the speaker outputs on the amp w/ a MM and everything checks out fine. The problem is the speakers...