Recent content by securitie

i got a 4ga amp kit and i ran it through the existing wiring grommet that has the bulk of electrical wires that run from the engine to the interior. it coulda grounded where it goes into the trunk but i can't really find any suspicious spots. i am about to go get more fuses and see what...

i'll have to give the whole set up a quick check. thanks for your help

cool thanks. i should probably do the big 3 too might help a little bit

its an audiofonics adf2845and a denon dca550

i was driving and listening to music really loud when my amps shut down. i pulled over and my main fuse was blown. is this a power demand my car can't handle or what?? any help greatly appreciated

there are no pins so i'll just have to drill a new hole. the factory wires are just about done for so i don't really want to bother with them. thank you

i have a denon dca550 4-channel amp and i want to run my front speakers to it but when i took off the door panel and all that i found a little plastic fuse box looking thing where the wires attach before the boot. my question is how would i run new speaker wire through the plastic thing in...

how do i know about the coils?

HIFONICS BXI1608D :* RMS Power @ 4-Ohm: 550 W x 1 * RMS Power @ 2-Ohm: 1100 W x 1 * RMS Power @ 1-Ohm: 1600 W x 1 * 1-Ohm stable * Super D class amplifier topography * Ultra-Fi MOSFET outputs * PWM MOSFET EXVP * SPC twin turbo torroids with Simpatico coil design * Fully adjustable Accu...

thanks everyone i don't tan at all, im so white paper is jealous

is that 2200 watts?

i have a set of rca's for the sub and 2 other sets. 1500 should run the subs just fine right not under power then?

whats up im derek and i want to become an installer some day but for now im like an infant so i'll be asking lots of questions and learning alot. im looking forward to learning alot for everyone here.

Im Derek and im new to here. anyways i got two kicker L7's in a kicker made box and i need to know what kind of power they need. Here are the specs according to the book: Nominal Impendance [Zn], ohm [per enclosure] 2 or 4 Power Handling* WATTS, Peak (RMS)...