Recent content by sdwrx

anyone?

Anyone have any experience with this amp? Any information is appreciated! http://www.onlinecarstereo.com/CarAudio/ProductDetail.aspx?ProductID=16450

Sorry for the newb question, but how would the RMS be split up between channels if I did bridge the 2 channels for the amp and use the other 2 for the comps??

I have an Alpine Type S sub dvc 2ohm+2ohm sub And CDT CL-61a components And a Profile AP1040 4ch amp http://www.profileusa.com/products_amps_ap.cfm Can I use this amp to run the 2 components and the sub?

I have a newb Gain question... I have an Alpine 9813 HU, Profile AP600 (300wRMS @ 4ohms), and a 10" Alpine Type S sub (300rms). Can I set the gain all the way up? I have bass boost set at zero and gain at 3/4 and it sounds fine. I guess I'm just wondering if you can set your gain too high...

I was under the impression that profile amps put out almost exactly what they advertise... is this not the case?

I didn't realize until now that the plasma lights up like it does From what I have read, the LT series is the same as the plasma without the lights Do you think PA is better buy than Profile?

I'm looking for an amp that will put out ~300rms. All I need is a good, affordable entry-level amp. I am not an audiophile by any means. I'm stuck between Profile and power Acoustic. I've hear good things about both brands. I'll be powering a 10" Alpine Type S sub DVC 2ohm+2ohm... so I...

I just picked up a new Alpine type s sub... it's a dvc 2ohm. My Amp is an older Mtx that is 280w bridged at 4ohm. I wired the sub according to the instructions for a 4ohm load, which my amp is already wired for, and nothing really happens. My amp's red power light is on, and when I turn on my...

actually you push down the top, and insert the wire into the side, and then release. thanks for the help.

they have both... in the manual they show the amp wires going in the push terminals and the jumper using banana plugs. Can I just wire the jumper via the push terminals?

so I went and bought some banana plugs, but they do not fit in the sub's terminals...

awesome... thanks guys

okay... then what guage wire should I use? 8ga? I'm just trying to wire this dvc 2ohm sub into a 4ohm load

What size banana plug jumper do I need for my 10" Alpine Type S sub??