Recent content by scfaust

i wanted to try and if i screw it up i can always buy a covor from year one

i just bought a older car with a vinal dash thats all cracked up. ive looked to bye a new one or have it redone but its out right now can i just put fiberglass resin on it filer sand and paint same with center consel or how whould i go about doing it if i did any know have any videos or a how to...

if i wanted to run 8 of these subs ( SI BM 10s (old models) and re-built them with several changes: 1) Slightly longer flat-wound coil (original was round wire) - USA made coils 2) Narrower / Taller Surround 3) Tied down tinsel leads Measured T/S Specs (coils in series): RE: 6.89 ohms Z: 8...

do you still have all of em , also what ohm load r thay i have some dc level 4 with 5 coils email me @ scfaust@msn.com att. subs for trade ether way

http://www.stevemeadedesigns.com/board/index.php?showtopic=63468

Vehicle: 1995 ford explorer Electrical System: 130 stock alt. (in trunk), 2 powermaster 975? i think Amplifier(s): (1) sundown 3000 RMS x 1 @ 1ohm, (1)americanbass 4 ch Subwoofer(s): (2) dc lvl 4 with 5 coils Box: 7ft tuned to 35, ports are6 x 22" long Mic: TermLab Song/Tone Played: 3 6...

sorry if this is a repost but here it is agine if it is.... http://www.carstereoforum.net/showthread.php?t=1446

i ran 2 12 type rs on a aq 2200d at .5 and 3 one the sundown 3000d and they took it and sounded good doing it i woundered y thay could handle all that power also.

i like the design. id love to see it be done and also to know more details.

im from toledo i remimber when i was young i knew a older guy there he showed me how to steal cars and to break into em ya i was a no good theif. i no longer do that **** i was young thought it was cool i also got to hang out with the older guys. but anyways, he used to sell and install ****...

ive had both sundown 3000d and aq 2200d i love both companies both and both amps, dj and jacob are down to earth ppl. as for db-r i called him befor i bought ether amp and asked about both plus hifonics, after talking to him i decided to go with the aq2200d so i do not think hes biased. because...

your not going to get help from thes ppl if u want help go http://www.caraudioclassifieds.org/forum/index.php http://www.caraudioclassifieds.org/forum/index.php these two site give me more help than this site.

http://www.caraudioclassifieds.org/forum/showthread.php?t=16512 did anyone see this or is it old news??

^^^ the same type i have on mine life time warrenty if u have a dealler put it on

do u have any pics of the subs whats the rms and ohm load