Recent content by rodzey5

http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&item=170355133398&viewitem=&sspagename=STRK%3AMEWAX%3AIT

thanks for the feedback. i will start my search again thanks.

i have 3 RE re series 12's wired down to a 2.6 ohm load. they are D4's with power handleing at 175w per voice coil. i am now looking for an amp to run this setup. $$$ is an object, so bang for the buck is important. any recommendations? is an amp rating in the ballpark of 1000-1300rms @2 ohms...

a goodmorning bump

a question about my re re12's. the re site says optimal sealed enclosure is .75 cu ft. after speaker displacement. playing around on winisd pro. i can have a win-win sitaution. when "creating" a 1 cu box after displacement. 1st win, lower extension. 2nd win i have the space to do it. i know you...

man, i need to replace mine! i haveto finish the truck first.

the bonne pulls it off. i have never liked 20's on gp's and i used to have one, but if that offset allows them to sit in the wells like that. it will look good.

thanks for the tip. so look into a hifinics that will give them both the 175 rms that they are cabable of handling.

on their site it doesnt look like they the make a dual 2ohm. back to the drawing board:crap: thanks for the feedback.

well the re's can be had for a hundred for the pair. so the more specific question is. "is a good fit with that amp?" thanks for getting bck to me.

i was pretty sure my low wattage system was going to consist of an alpine m350 running 2 reaudio re10's at 2 ohms. Seeing all the information available to me is this still the right set up?

yea that is a nice box. good work.

newb in columbus

i have been watching this sub too. thanks for the site and good price.