Recent content by Reit38

finally got around to building the box. was tuned way to low sub was constantly bottoming out it sounded like and had lots of port noise. heres better dimensions that i came up with

So hook it up bridged and see how it does. I don't care bout the amp. Just don't want to hurt the sub

****. I already had the amp.I was lookin at that pic when I ordered the sub. Guess I seen the 4ohm and thought that's what I needed for a sub

why does the owners manual say that bridged it it wants a 4ohm sub? [/img]

Rockford Fosgate Punch P3001 Mono subwoofer amplifier 150 watts RMS x 1 - Reviews at Crutchfield.com

thought it was 300W x 1 @ 2-Ohms RMS? i have one dual voice coil 4ohm sub

Would a rockford p3001 work then. Buddy has one I could pick up cheap I think

i meant using one channel vs bridged at 8ohms

mclerico83 Accomplishing the same rms correct?

its a dual voice coil

i have a rockford 201s and a dvc sundown e8v2 4ohm. is there anyway i can wire these two together successfully since theyre both 4ohm? and how would you go about doing it. thanks im in a pinch

duh brain fart im understanding the pic now........port could be external if it was top left corner to go over drive train hump did another quick measurent tonight when i got off work in the dark and i came up wit for another box if it would work better 5.25x10x34 for demensions if i go over...

dumb question whats going thru the middle of the sub cutout on the first pic?

hey thanks alot ill give both boxes a try next week hopefully

i came up with a ported at 0.605 @35 but Basic Car Audio Electronics keeps saying this.... **ERROR** Check your dimensions. The port is too long to fit inside the enclosure. You may need to use a curved port, less port area or a higher tuning frequency. my port length is 10.26? thats...