Recent content by realflow100

I cant move anything from where it is. landlord doesnt allow anything blocking easy access to the windows for "safety" reasons. so I cant move everything to where the bass hits the hardest because its right in front of the windows in the opposite corner of my room from where im sitting. my desk...

I just want to ensure my subs get clean power. plus my room has really bad cancellation below 40hz or room gain around like 50hz in my sitting position so i need alot of power to hit the lows like below 40hz and i plan on upgrading to better subs eventually when I can too. below 40hz the bass...

it was the cheapest I could find for the watts at the time. less than 100$ and the power supply for it was only 20$ free shipping on amazon. but moving up to close to 1000 watts RMS at 2 ohms is much harder to do in home subwoofer audio and find a good deal on that is a good bargain.

its definitely 34hz i tested it playing a sinewave sweep and stepping through the frequencies one by one and its dead on 34hz exactly. works fine! the MTX subs werent as good. has less xmax. cheaper terminals. more cheaply made. the magnet had sharp jagged raggedy edges on the inside edge of...

I'm not in a car im in home. everything setup in my bedroom I have no bass boost set. turned off completely. my box is ported tuned to 34hz and not sealed. it hits down to about 22hz strongly. my subs do not even get close to bottoming out without subsonic filter. even playing a 20hz sinewave...

I got a new set of subs cause one of the terminator subs terminals broke when i was moving them to my new box I got tuned 34hz with 1.8 cubic feet per sub with separate chambers I got some DS18 SELECT 4ohm 12" subwoofers they hit harder and sound cleaner and get louder and deeper too. a fair...

I play all kinds of music some even have below subsonic frequencies bass i love you has some frequencies below 10hz and some other songs have super deep bass like 20hz violation and subsonic world and stuff have bass below 20hz and a song called 17 hurts

ive not done anything wrong just asking questions  :(

mine are definitely tuned to like 45 to 50hz or something really high. 25hz and below it gets quieter and stuff starts vibrating and jumping up and down a lot. and i want to cut down stuff below like 25hz  so its not vibrating stuff so much and my subs look like they are about to jump out of the...

please dont assume i have a mental illness. its just a question. and thats just rude to say.

like i set the low pass filter first. then set the bass boost to just over half so until the frequency that outputs the most power is around 40 to 50hz with the gain all the way down and turn up the gain so that the voltage around port tuning is set right on the amp so the subs get the most...

Well you'd never guess what i did to fix it! I just took a sprits/spray bottle and filled it with just water. sprayed some all the way around on the spider so it was wet and damp. flexed the speaker a couple times and now its completely silent! Weirdest fix ever but interesting that it worked...

i dont hear any other mechanical noise except the small ticking sound that sounds like its coming from the spider i think. the other sub has almost no mechanical noise at all except for the quiet air sounds coming out the venting at maximum excursion

Im pretty sure it would instantly break if i did that. it probably just make a sharp loud pop noise and be dead within a half a second. and I dont want to deal with the smell that would make.

thats just going to burn it up and ruin it im not going to do that!