Recent content by realdeal23x

Bridging will combine both channels into one. Meaning, since i have a 400x2 amp, at 2-ohms per channel, youll get 800 watts at 4-ohms bridged. This is considerably more than the 200 watts per channel youd would get at 4-ohms. So basiclly i will need to get a dual 2-ohm subwoofer, or a single...

any suggestions on a 12 that slams hard thatll work with the amp.

i need a 12 that i can pound the shit outta and turn it as loud as i want without havin to worry about it frying. lol i was going to get a mojo 12 with mmats amp but then i figured i already got a "decent" amp i just dont know what kinda speaker i can give it im use of using monoblock amps now...

also are you saying that i can only get a 2ohm speaker for my amp if i bridge it .

yea the box isnt anything special it basicly came with the install. the port vented slot is 13 1/2 x 2 inchs and its 13/1/2 deep in the box. its on the right side of the box going vertical.. looks like a long skinny rectangle. 3/4" American MDF wood Volume is 1.49 Cubic Feet 12" Woofer Hole...

budget under under $500...box specs would be DIMENSIONS: 18" Wide x 16" Deep x 13.25" High and its a SINGLE 12" SUBWOOFER SUB BOX VENTED PORTED ENCLOSURE.

u recomend a nice 12 i can hookup to the amp better then the m3

i guess what im asking is will like a type x or something around 1000rms work with my amp? thanks

the gain is not even half way up so i dont know about that being the problem ..... and obviously when i say it keeps blowing it means i blew one the replaced it with the same one lol im not a pro i know just basic stuff about car systems i just wanna know what you guys think i should do i...

Hey i have a power bass asa 800 2-chanel amp hooked up with a memphis m3 500rms 12" sub. The sub keeps blowing because i think the amp puts out to much pwoer which is good i guess. The question is that i want to get a new 12sub and was thinkin alpine type x which is about 1000rms 3000watts and...