Recent content by Rawr-DQ

Checked all mosfets Tim your pm box is full

thanks for the help; i pm'd ya

well I don't mind pulling and testing them. But I need a basis on how the protection system works; and how many variables, chips, and circuits could be involved? I have 102 volts but no power out and don't know if the protection system is analog or digital, however I don't see many chips and...

nah I doubt it; i've had her for years

In yellow rub; pink manufacture damage I did some testing; I have a 12v powersupply thanks to a optima d31a; 1125 cranking amps; 900 cold; 75 amp hour battery just sitting around...I did millivolt testing From the positive terminal; I can measure hundredths of a millivolt; I got ~29mv on...

unfortunately, after re-installing my car audio I found my sundown amp going into protect.It goes into protect immediately; the power light turns on about 1-2 secs later; 5 seconds later the two relays marked with a purple X close/open(click)...; unhooked from speaker; I found manufacture...

Painted with silicone

Ok well I got to cut the ports; then it rained and lightninged, so I went inside. I got back out and went ahead and painted it with the same silicone I had before. I figure it will seal better when I put the cover on. The ports are 15.5 inches; changed the peak; but I have enough room for some...

Ok well I'm going to cut the ports and put elbows on them! Just wanted to make that clear; However 6" elbows are harder to come by than I thought; so I'm gonna visit a sewer guy I know or order them online. Today I'm going to wire the amps and cut the ports; going to leave it sealed. I've...

Look ma no screws! I love my corner clamps for sure; I also love clean even cuts; very few gaps. I line up my clamps; test fit; rub my finger at the seems and adjust the clamps till I don't feel any edges; tighten one side of the corner clamps; raise the board; brush glue; drop; clamp corners...

yes; and what he said ^. open it up and check for burnt mosfets; make sure that fuse is good, if that is a fuse; It should be a simple car fuse, slow blow; you can see if its broken. even smell it; if you know the smell of burnt electronics; you can pick up the scent quite easily; it is a very...

If the H fuse near the power terminals is good; open it up (if no warranty) and see if it blew a mosfet or burned a cap (look for swollen caps) burn marks ect. I'm guessing its bad; since you have 12v+ to the remote wire; you're ok; you can bypass it by putting the +12v to the remote wire...

EXCELLENT WORK! I love your fiberglass skills; kudos to you. Inspires me to rebuild my car.