Recent content by PSD POWER007

Does anyone make a custom big 3 kit for diesel trucks? Mine is a single alternator. I'd assume power from alt to each battery, ground for each battery and block ground. Didn't know if you would also upgrade the wire the runs from one battery to the other too. Not much info out there.

I have a mint 2002 Rockford Fosgate Power 1000bd. Comes with everything that it did from the factory. Even in the original box with birthsheet, manual, bass knob, etc. I ran it at 1 ohm for a few months and it made good clean power. Didn't even get warm. I did have proper electrical. I mean it...

I have a LNIB old school 2002 RF Power 1000bd. Original box, comes with end caps, bass knob, birthsheet, manual, etc. Only has about 6-8 months of use in its lifetime. Looking around $275 shipped.

I have a LNIB old school 2002 RF Power 1000bd. Original box, comes with end caps, bass knob, birthsheet, manual, etc. Only has about 6-8 months of use in its lifetime. Looking around $275 shipped. If you decide spend just a bit more.

I have a LNIB old school 2002 RF Power 1000bd. Original box, comes with end caps, bass knob, birthsheet, manual, etc. Only has about 6-8 months of use in its lifetime. Looking around $275 shipped.

FYI, I have a mint 2002 RF Power 1000bd to sell. $275 shipped. Comes with original box, birth sheet, bass knob, end caps, manual, etc. This amp only has about 6-8 months of use total. It is a 10/10 cosmetic and 10/10 mechanically. Just food for thought! PM if interested. Should work fine with...

I have an old school 2002 RF Power 1000bd that's in mint condition. Comes with original box, birthsheet, manual, bass knob, and end caps. $250 shipped.

I'm just so on the fence about what direction I wanna go.

I have an old school grey Rockford Fosgate Power 1000bd. Built in 2002, had since new and only has about 6 months of total use. I have the original box, birth sheet, bass knob, etc. Just throwing that out there...

Meant to ask you in the other thread, does this come with the gain knob?

Let me think about it. On the fence...for $100 more I can buy brand new.

Shipped to 31808?

How old are these? Very interested.

Still looking!

I have the means to build my own enclosure no matter how complicated. I just need a good box design. It will be going in my Ford Excursion fitting as tight as possible behind the third seat. I've got 48" wide x 14" deep x 18" tall to work with. Was thinking common chamber with woofers up and...