Recent content by Phlox

Another quick question, the sub is 375w rms, the amps total bridged output is only 120w rms on mono,so the sub is too strong? Will draw too much power from amp? Cause at low volumes even with bass full and gain maxed on amp it plays fine, as soon as the volume goes up a. Bit it cuts out. I know...

At the moment a 20guage or sumthing,i know its too small for the high amperage draw of the amp, but its for testing purposes only, going to buy an amp cable kit tommorow thats designed for a 1700w amp, then ill let you know again, the gains arent that high, probably round about half, also going...

Heey guys, i found out i was a 20k pot, and had a single pot laying around also 20k , so i soldered that on and just joined the other piece with wires as it was a dual ganged pot, foun a blown resistor on rca input and replaced that aswell and bobs your uncle! It works, except for the sub being...

Its completley broken off, broken off inside the casing, so ill guess ill have to replace it then

Im gonna try it, what i think is gonna happen is that it should work and ill then have only one pot for both volumes which if fine, i only need one bridged channel anyway, i only have one sub so its fine

I know i should solder on a new one, but the thing is the broken off one doesnt have the resistance values and so on on it neither does the other one have any values, thats why i thought of just soldering the wires to the working pot amd give it a try

Hi all , im new here, and ive got a question. I recentlly got a secondhand 4 ch starsound amp for almost for free, but one pot oi broken off, i was wondering if i could just resolder the wires to the same ones on the other pot? Its the x-over pots and it has got 2 , just one is broken of...