Recent content by peepr

jeeze sorry if my intentions are bad. its not like i intend to drive through residentials areas at 1 a.m. just to irritate people. i just want people to know ive got something in my trunk. its a penis envy thing.

basically what im asking is my setup the norm, like did i do what i should have done or is something wrong. the bass shakes the car but its not deep. i cant feel it when im outside the car or in the house. i remember last year someone had a system that i could feel/hear over like 1000ft and...

ok, i think i may have figured it out. I set my deck to subwoofer on, sub level 15, fade rear to +2, volume at 18-20 out of 35. With this combo i can hear the music from the front and get bass from the back. my subsonic filter is set to 30hz and my low pass is set to 100hz. with this...

its an alpine cmd-9821. its got one set of pre amp outputs. it also does have sub control. i can either turn the sub on or off and it has subwoofer level control. the deck has a bass frequency changer and i just set it to 60 or 80. when my sub is playing, i get no music out of my front...

gosh dangt. well ive found sumthing else out. my deck is treating my sub like a rear speaker. to get my sub to make bass, i need to fade it all the way to the rear and turn my vol up to 30/35 instead of 16/35. When i do this, my sub moves a fair bit and it acts "normal" im thinking that it...

MMM i just tried it this morning, same problem. i am now going to wire it in series and see if that helps even though it will be at 8 ohms. this is so gank.

for my voice coils i took a piece of 12 gauge and connected my two pos terminals together and then another piece of 12 gauge and connected my two neg terminals together. i then connected my speaker wire from pos on sub to pos terminal on amp same for the neg. i did this to achieve a 2 ohm load...

Well i hooked my rcas and speaker wires up correctly and a little bit changed. when i turned my gain to about halfway, the sub would putter more/faster. It moved maybe 1 mm at most but there was little to no bass coming from it. How clean does my power wire connection have to be? when i...

cmd-9821. not the best alpine deck but it gets me through. i think i just have the speaker wires and rca cables in the wrong spots. I should be able to properly look at it tomorow when its light out heh.

im going to fiddle with it tomorow morning and if it still doenst work ill go and buy a DMM. thanks for the responses fellas.

today mr. ups brought me my knukonceptz wiring 4gauge wiring kit to go with my orion 1200d and my RE SE12. I hooked it up as i thought was correct, turned on my deck, an alpine which i installed myself, and fiddled with the bass settings( turning on the sub, bass type 1, freq ect..) my problem...

id rather like to stay away from lanzar unless its an opti1000. Also want to stay away from sony,boss,blitz,dual,light audio,pyle, and other craptastic amps.

I just got my RE SE12 today and im lookin for a few good amps. Ive got around 230 shipped for a decent 700-800 wrms @ 2ohm amp for my single 12. If anyones got a viper 1200.1, id rather buy from you than from ikesound.