Recent content by NYCkid718

ok so i decided to do the following, please tell me if this can work as well... my focus is to get the max out of my amps and speakers and while staying at a stable impedance. I am going to wire my 4 mids to a single amp. Then im going to run my 2 6x9's into 2 channels of a 4 ch amp, and the 2...

so if i do it like this my tweets will blow? How should I run this then?

I have 4 midrange speakers and 2 tweeters. All 4 speakers are 8 ohms and the 2 tweeters are 8 ohms. If I wire 2 speakers and 1 tweeter together on one side and 2 speakers and one tweeter together on the other side into 2 separate channels, how many ohms is that gonna give me at the amp per...

I have 2 DVC 4 ohm subs and a 2 ch amp thats rated at 2 ohms. I currently have each sub wired down in parallel to 2 ohms each and then one sub to each channel in stereo mode. I'm assuming each channel is putting out the max wattage since the amp is rated at 2 ohms. I want to bridge the amp to...

2 15'' L7's DVC 4 ohms in ported box- 500$ Soundstream Digital Bass Driver- New in box- 85$ Rockford Fosgate 360a2- 100$ Pair of O2 8'' speakers- 150 watts rms each- new in box- 85$ Four 6 1/2 whip audio midrange speakers- 100 watts rms each (Similar to Beyma and o2)- 200$ Will have pics up...

it wont be just as loud because its 500 watts rms less than the 2 12''s and my amp would blow the one 15 at 2 ohms... and im not running at 4 ohms and not get the whole output of the sub.

make me an offer.... I will try and post pics up as soon as I can... I am also open to trading for 12'' l7's dvc 4 ohms and some money on the side... these dont fit in my 2000 jetta lol

Selling 2 15'' L7's ... 450$ These are DVC 4 ohms and are the blk/ gray model. I am fairly new on this board... but I purchased an enclosure from SPY and he can assure you that I am honest, and responsible.

Looking to trade my 2 15'' Kicker L7's DVC 4 ohms for your 12'' L7's and some cash... Money offers also accepted/ considered.

I have a yellowtop battery... ****... So should I get rid of them and get my L7 12's again?

i traded my 2 12's for these... (too good a deal)... So I'm holding on to these.

Ok guys, one of the guys on this forum is going to build me an enclosure, and I need help coming up with a quick design so that I can tell him what I want. I have 2 15'' L7's that I am going to put in a 2000 Jetta (LOL, I know). So here is the problem. I wanted to port them at about 34-35 hz so...

so if you wire each sub to 2 ohms and put one to each channel you got 2 ohm stereo? and if you wire each sub in series to 8 ohms and then in parallel into mono you have a 4 ohm load bridged? Is this correct? Also, which is the better option... 2 ohm stereo (2x700) or 4 ohm bridged (1400x1)??

l7's... yea

But how so??? Everyone says there cant be a 2 ohm load made by 2 4 ohm DVC subs.... and the amp puts out that wattage at 2 ohms.... so how could it put out its rated power of 2 ohms but the subs cant be wired down to 2 ohms??