Recent content by Nova5

Zone isolation is the easiest. A switch in the rear can trigger a set of relays which control whether the HU up front or the audio source in the rear outputs through them. You can use a pair of 3way switches if you want to be able to control it from both the front and the rear. The 3way...

antenna adapters are just like speaker adapters to hook to the factory system.. wire with specific ends, no fancy electronics. Nothing that should degrade the signal. Look and see if the antenna adapter fell out of the either the HU's connection or the antenna from the adapters connection. Had...

I saw changes in the ohms reading, sporadic/random values. It wasn't stable or linear as the cone was pressed on lightly.

The crossover box and tweeter remained connected throughout. Only the woofers connections came off the woofers themselves, the wire remained bonded to the terminals on the crossover. I would doubt a failure on both A and B channels of the amp showing the same problem. Not unheard of by any...

dmm? Digital Multimeter? Looking for Ohm or Volt(generation) change? The whole speaker system makes the audio "Thump" noise, its not isolated to one channel, and while working the speakers don't have distorted or rough sound if it helps.

I have a suspicion on where the fault lies.. Car. 1997 Chevy Camaro Z28 Infinity Kappa Component 60.5cs's in front doors. W/Tweeters Infinity Kappa Component 60.5cs's in rear sail panels. WO/Tweeters Infinity Kappa Subwoofer Ttop stealth box. Kenwood Excelon 5 Channel Amp JVC Arsenal HU...