Recent content by mile098

  1. mile098

    DD 2515 parameters?

    bump, anyone?
  2. mile098

    DD 2515 parameters?

    k, been a while since i was last here.. i'm about to purchase a DD 2515, but am unable to find T/S parameters, mounthing depth, cutout hole etc. dd has the info for 2515a on their site, does that apply? help me out here thankx
  3. mile098

    Post Up Your Piercings

    lip ring for a year and a half, not any more tho
  4. mile098

    Dramarama Silverado build log

    looks good, pics of the amplifiiers?
  5. mile098

    GF that always says no to me!

    Op: grow balls
  6. mile098

    How bad is this?

    leave it, theres nothing wrong with running 1 channel per coil. the difference in signal is minimum. someone said earlier to set the mono signal on your sub out, thats good advice. late nite tip gets pretty low, prlly heated up the coils a lot. no worries youre fine
  7. mile098

    Thumping Noise Problem ...HELP

    take the ground directly from the battery
  8. mile098

    New to Audio, Need Some Help on HU...

    the highs, no matter what tweet i used, from pioneer, to phase evolution, dls, whatever its so f***ing annoying. i tried killing it on the Xover, EQ, different slopes, no matter what i did it always emphasises aggressive higs. but thats just me
  9. mile098

    New to Audio, Need Some Help on HU...

    its all about personal prefrences, I for one am never going alpine again, and as far as i'm concerned their last half decent deck was 9835. i'd reccomend going JVC or panasonic, they have that all rounder sound. panasonics are a bit shy on bass though.
  10. mile098

    Wall Build Log...

    nice, nice, too bad all 4 don't fit, but three should do just fine
  11. mile098

    Would you do this?

    i wouldn't put them in a common chamber box if theyre not on the same amp
  12. mile098

    RCAs are about 3 feet short?

    running them on the same side can cause noise. personal experience
  13. mile098

    JBL W12 GTi MKII

    those subs can take a lot more power, how did you manage to blow the cone out?
Top