Recent content by mikelaubach

Who is running this event?

Ok, so "some" amount of forward progress. I was liking have a sub and hearing/feeling the bass in the music, but had not ported it yet, and could hear the sub having problems in a 1.75cf sealed enclosure. The achilles tendon is healed up, but I have far from original range of motion and still...

I'm not young, and just graduated law school in May. Work 40 hours and still going to school. So I understand when school starts again and it's supposed to be summertime, despite NOT being "young." And all problems are relative, so for him, this IS a big deal. For now.

You'll start on Aug 10th???? Fewkin-a, indeed!

PM sent.

I put these in the doors of our stock Audi A4, replacing the stock paper (crap) ones that it came with. I did one and then compared right away. The stock one is more efficient (it gets louder at any given volume level). BUT this is MUCH better sounding. Once I replaced the other side, it...

So, what is the status Suteman? Amp work with the new fuse?

The June show got canceled. boooooo

Wow, we be all over the map here! LOL You have the amplifier in the car, and there are three power lines going in - one for hot (red I hope), one for ground (black I hope), and one fore remote (blue I hope). I like to follow convention if its not obvious. My understanding of the above is...

In any direction. IE - that 0ga run to the rear battery should have a fuse before it gets to the rear battery. If not, then if something happens to the cable under the hood (after the front fuse), then you have a 0ga line being fed by the rear battery towards the front. Fire. Fire! Fire...

The real issue were the tires. The catching fire was a corporate-wide issue. The cruise control cutout was changed from the old brake pedal mechanical switch to defeat to a new-style master cylinder mounted electrical pressure switch that would leak and get brake fluid in and around the sensor...

So do the two radios have the same pin-outs? I do NOT mean the same SHAPED plug, but are the pins on the two radios the same - pin 3 is power on them both, pin 4 is ground on them both, etc. Just because the plug shape is the same, does not mean the pin use is the same. I found that there are...

Talk to sleazebagger, you guys have the same sort of crazy-arsed electric crap going on. LMAO

Are the speakers attached or not? The fact that you are getting anything at all says that the majority of the amp's systems are working. Won't some amps not behave properly without a load? Install the speakers and wire and check again AFTER turning the amp gain all the way back down...

Everything said above is a good starting point. While that is not untrue, there are plenty of threads on this site for setting gains using a DMM. While is not as perfect or easy as clamping to get the power output at a specific frequency, it is close enough to properly set the gains.