Recent content by Mikeaudio

What are your gains set on your amps?

Just saw your post. Thanks, I did relocate the amp about a week ago and that solved it. I just don't understand how the vibration could cause it to cut out. Thanks for the advice.

What do you think it would be in the HU.

On my amp the light never turns off. It doesn't turn red or any color, it stays blue. I just installed my new subs and they are cutting out the same way my old ones did.

Dammit! I'm starting to have the SAME problem again! How is this happening? Can anyone give some more troubleshooting tips.

Do you have good grounds for your amp? Ex bare metal without any paint?

I found problem fellas, thanks for your help. I was checking all my wiring today and as I tugged on all of them to check for a loose connection the remote wire for the amp came out. So I swapped it for a new blue one.

Here area couple of pictures. I didn't remove the cap, to tired from work.

I'll take the cap out tomorrow and try to show some pictures. The thing is that it started cutting out before the cap. Another note. I took out the subs today and saw that some smoke was coming out of the box. I'm starting to believe that one of my subs is going out. I already ordered new ones...

My subs are 10" pioneers. Model TS-SW1041D. I have them in parallel from the amp (alpine mrp m500, 500wrms @ 2ohm) using #12awg . I have a 2 farad cap (planet audio) feeding the amp. I have already upped the ground wires to #4 awg (battery - to fender, to engine block, to chassis) also upped...

How? Not with what.

How do you haveit connected?

My subs work fine and sound great. But around 2/3 of the way up volume they begin to cut out! I've checked all my wiring, grounds, impedance, rms watts, voltage, connections and checked for damage to the voice coils. I can't find the problem. Help please. Thanks.

In short. My subs are cutting out at high volume. Please direct me to the proper thread, one that is active so I can finally fix it.

Can you explain the sound better? Have youtaken a look at all the fuses that would be under the hood and by the door panels next to or under the dash. Just in case. Just off what I read it seems like the factory head unit went out.