Recent content by michael26

Stern makes it worth it IMHO!

I place mine with the connector in the vise and the barrel side up. Using my hobby butane torch, I fill the barrel about half way full of solder then insert the stripped wire into it and leave the flame on the barrel for about 10 seconds. No cold solder joint and they last forever.

*cough* *cough* Bull Pucky:rolleyes:

Next time don't play brake check games. I doubt you would have kicked his *** since you chose not to get out the first time you felt the impulse. Chock it up to experience and learn from it.

We only use ProEngineer 3D modeling at my work.

I couldn't post since I'm not a member over there, but the beeps you hear when starting up are a code that tells you what's wrong. Count them (ie. three short, 1 long 2 short, etc). Look in the m/b manual or go online to the m/b mfgrs site and look in the support section for what they mean.

Hit them with the number of watts you're talking about and you'll think you dies and went to heaven. With that power they get amazingly loud. I wish I could afford a set

Excellent batteries.

I not only have a Beretta 9mm under my mattress, I'm pretty deadly with it

Pfffft, then don't do it. Just trying to help:rolleyes:

If anyone is injured while you're in a wreck, you must inform the DMV within 10 days of the accident or risk a suspended drivers license. At least in Cali. I didn't do this once and got a letter telling me b/c I didn't do this my license was being suspended for a year in 30 days. I could...

If anyone was injured make sure you inform the DMV within 10 days. I had that happen once and forgot to and they were going to suspend my license

That is one ugly pooch

Not necessarily. My Alpine h/u will shut down with that much over voltage.

Didn't clip the hell out of the signal??????