Recent content by max v

Is there a chart that tells you what gauge speaker wire you should use? I will have a 1-ohm on my amplifier that puts out 900w rms and will have two 4-ohm DVC subs. What gauge speaker wire should i be using?

Any way to wire it into 2 ohm load?

So then if i wired at 4 ohm, i would get 500 while at 1 ohm, i would get 600? Doesnt being CEA compliant mean anything?

I was planning on wiring the subs in parallel, but wouldnt the amp still read it as a 4 ohm load even if the subs are actually 2 ohm each?

Hi everyone, im new to this forum, so this is my first post. I recently just got 2 JL Audio 12w6v2's (12 inch) and i already have a kenwood 910-5d amplifier. Since these subs are dual 4-Ohm voice coils and this is a mono amp, from my understanding, i can only have it wired as a 4-Ohm load or...