Recent content by macsdad

Hey dude, I finally copped a pair of 06 era re audio sx10s, d4 on a 3rd gen incriminator audio ia20.1, simply love them. Well all those years that it took for me find them nib, new deadstock from woofersetc.com about a year ago.

You,sir, were correct. I was concerned more with going from ported to sealed, but these two 12s do very well. Less drain on the electrical, less sonic assault on the vehicle, and clean bass.

Stereo Integrity hst12, only needs .6cuft after displacement. I have mine in a 15 inch double wall birch ply cube, .55cuft after displacement. 2000wrms, on an incriminator audio 3rd gen ia20.1. Good from 90 down to about 15 or so hrtz, love it comes in handy when I need extra space in the hatch...

I wish I had the coin for these, GLWS dude. Just please make them stop calling my name. Someone is going to love these subwoofers. I still regret selling my tc2000 12s.

Yes, he is a very stand up guy.

After doing a little more research, the fs is actually 23 on the 302s. Thank you dude.

I am currently running a single dc audio xl spl10d2, its spl is 85.9 and an fs of 41.7. I am going replace it with a pair of mb quart pwe302s(d2 12 inch subs) which have an spl of 90, and an fs of 30. The amp I am using is a 3rd gen incriminator audio ia20.1. On the mb's it will be a 2 ohm load...

Familiar with him, may be the route that I go when I do decide to have them rebuilt.

I have seen that page, and have reached out to them, just looking for options, thank you.

How much would you charge to rebuild a pair of punch hx2 10s, d2 ohm?

My current set up is a pair of their 06 sx10d4s, love them. 8 layer flat wound voice coil, 1000wrms per, on a 3rd gen incriminator audio ia20.1.

I used to have that audio control loc, it only goes down to 33 hertz, I have since replaced it with a JL audio loc22, that goes down to 3 hertz, much better low end output. My vehicle emitted a low hertz noise cancelling hum, that was amplified by the loc22, so I had to have that disconnected...

Great dude, still enjoying that ia20.1, on a pair of 06 re audio sx10d4s dude. Hoping that you and the fam are doing well.

What's up AnthonyO? How's things going in your neck of the woods dude?

I have their 3rd gen ia20.1, the last version capable of being run at 18 volts. I am running mine at 1 ohm on a pair of 06 new dead stock re audio sx10d4s, loving it. In 2.5cuft after displacement with a 5x17 inch octo port at 32hrtz. Due to a trade correction, I only have $100 out of pocket. I...