Recent content by luma1234

Can you wire some mono amps from 1 - 4 Ohms? Or can you just wire them to 2 or 4 ohms, and how do you go about doing this? Thanks.

If you had a 3 ohm sub and you wired it to a 2 ohm stable amp, would you just wire it to the amp in 2 ohm mode or bridged into 4 ohms? I'm confused

I need help. If I wired my 6ohm JL Audio w3 into 3 ohms, how could i hook it up to a mono amplifier? Or could I bridge a stereo amp into 4 ohms and hook my 3ohm sub up to it? I need a way to wire this sub to an amp while being stable and mainting the rms power range which is 300 watts. Thanks.

I have a jl audio w3v2 6 ohm dvc sub. I can wire it down to a 3 ohm load or a 12 ohm load for a single sub. I need help on finding an amplifier that will run this sub at 300w while being stable. Should I buy a mono amp with a 300w rms 4ohm operation, or 2ohm, just help me. Thanks a ton for...